Pull Bar Spring Linear Rate

Pull Bar Springs

Put the Power Down

Used mostly for circle track racing, the Pull Bar Spring is mounted on a pull bar between the chassis and the rear axle. Its job is to absorb the torque from drivetrain, increasing rear traction.

  • Ultra-lightweight for reduced unsprung mass
  • Block and sag resistant
  • Maximum travel with smallest block heights possible
  • Each spring individually tested

Standard Compatibility

Pull Bar Springs are progressive and are all available in 6.75” length / 5.00” OD - compatible with most pull bars on the market.

Pull Bar Spring drawing

Upgrade to Eibach

Use the dimension search below to find springs that are best suited for your setup. Not sure which parts to choose? Contact Eibach Tech Support or an authorized Eibach dealer to help you decide what is best for your application.